34323 Data Path Control DPC: SCSI parity error detected Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 The firmware checks the parity of each word of image data sent by the workstation. If there is a discrepancy, this unsolicited error is reported at the end of the image. Note that a parity error does not cause the image to abort or suspend, so plates should be inspected when this message is reported. The SCSI hardware should be checked as described in the Service Manual's Troubleshooting section. If the SCSI hardware does not seem to be the problem, the possibility of external electrical noise corrupting the SCSI data should be investigated. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Faulty SCSI hardware. External electrical noise. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:03 2008 PST